【Open frame】Q1D-5120V
120W
Server ,Workstation ,Storage System ,IPC
165x83.8x39(mm)
6.5x3.3x1.54(inch)
VOLTAGE： 90～264VAC FULL RANGE
FREQUENCY： 47～63HZ
INPUT CURRENT：2A (RMS) FOR 115 VAC
1A (RMS) FOR 230 VAC
INRUSH CURRENT：35A MAX. FOR 115 VAC
70A MAX. FOR 230 VAC
Output VoltageTD
Output Current Min.
Output Current Max.
Regulation Load
Regulation Line
Output Ripple & Noise Max.[P-P]
+5V
0
14
±5%
±1%
50mV
+12V
0.1
8
±5%
±1%
120mV
-12V
0
0.5
±5%
±1%
120mV
+3.3V
0
12
±5%
±1%
50mV
+5VSB
0
1.5
±5%
±1%
50mV
?TEMPERATURE RANGE：OPERATING 0℃～50℃
?HOLD UP TIME：41mS MINIMUM AT 115V FULL LOAD
?DIELECTRIC WITHSTAND：INPUT/OUTPUT 1800 VAC FOR 1 SECOND
?INPUT TO frame GROUND 1800 VAC FOR 1 SECOND
?EFFICIENCY：82%±2% TYPICAL，AT FULL LOAD 115Vac
?POWER GOOD SIGNAL：ON DELAY 100mS TO 550mS，OFF DELAY 1mS
?OVER POWER PROTECTION：110～160% MAX
?OVER VOLTAGE PROTECTION
?SHORT CIRCUIT PROTECTION
?SAFETY : TO MEET UL, CSA, TUV
?THE POWER SUPPLY SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE/ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STAND BY).
?AS LOGIC LEVEL IS LOW，OUTPUTS VOLTAGE WERE ENABLE ?AS LOGIC LEVEL IS HIGH，OUTPUTS VOLTAGE WERE DISABLE
*THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS.
120W
Server ,Workstation ,Storage System ,IPC
6.5x3.3x1.54(inch)
FREQUENCY： 47～63HZ
INPUT CURRENT：2A (RMS) FOR 115 VAC
1A (RMS) FOR 230 VAC
INRUSH CURRENT：35A MAX. FOR 115 VAC
70A MAX. FOR 230 VAC
| Output VoltageTD | Output Current Min. | Output Current Max. | Regulation Load | Regulation Line | Output Ripple & Noise Max.[P-P] |
| +5V | 0 | 14 | ±5% | ±1% | 50mV |
| +12V | 0.1 | 8 | ±5% | ±1% | 120mV |
| -12V | 0 | 0.5 | ±5% | ±1% | 120mV |
| +3.3V | 0 | 12 | ±5% | ±1% | 50mV |
| +5VSB | 0 | 1.5 | ±5% | ±1% | 50mV |
?TEMPERATURE RANGE：OPERATING 0℃～50℃
?HOLD UP TIME：41mS MINIMUM AT 115V FULL LOAD
?DIELECTRIC WITHSTAND：INPUT/OUTPUT 1800 VAC FOR 1 SECOND
?INPUT TO frame GROUND 1800 VAC FOR 1 SECOND
?EFFICIENCY：82%±2% TYPICAL，AT FULL LOAD 115Vac
?POWER GOOD SIGNAL：ON DELAY 100mS TO 550mS，OFF DELAY 1mS
?OVER POWER PROTECTION：110～160% MAX
?OVER VOLTAGE PROTECTION
?SHORT CIRCUIT PROTECTION
?SAFETY : TO MEET UL, CSA, TUV
?THE POWER SUPPLY SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE/ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STAND BY).
?AS LOGIC LEVEL IS LOW，OUTPUTS VOLTAGE WERE ENABLE ?AS LOGIC LEVEL IS HIGH，OUTPUTS VOLTAGE WERE DISABLE
*THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS.